Remove a Frame
If you are using a keyguard or TouchGuide, remove it from the frame.
Remove the six screws that secure the frame to the device—two on the top, two on the bottom, and one on each side.
Important: If you are replacing the frame, set these screws aside. You will use them to reattach the new frame. If you are not replacing the frame, store the screws in a safe location in case you later decide to reattach the frame.
⚠ Loose screws could be a choking hazard.Pull the tabs on the top of the frame loose from the device.
.png?sv=2026-02-06&spr=https&st=2026-11-20T02%3A46%3A10Z&se=2026-11-20T02%3A57%3A10Z&sr=b&sp=r&sig=vE2fxzuukbSoXB%2F87%2Bhs7T3%2Fzue8tsXygopdCqdi8Sw%3D)
Tip: You may want to use a flat-head screwdriver or a similar tool.
Pull the frame loose from one side of the device.
Pull the frame loose from the other side of the device.
Pull the bottom tabs loose from the device.
.png?sv=2026-02-06&spr=https&st=2026-11-20T02%3A46%3A10Z&se=2026-11-20T02%3A57%3A10Z&sr=b&sp=r&sig=CWl91ei%2BIdAyyuPa1siBaQqh4x7S06vllWlUrvC8Wgg%3D)
Attach a Frame
Important: The frame must be attached before you can mount a keyguard or TouchGuide over the screen.
Position the frame over the front of the device.
Press the tabs at the top of the frame onto the top of the device.
Pull out the sides of the frame and fit them over the edges of the device.
Pull out the tabs on the bottom of the frame and fit them over the bottom edge of the device.
Press on each side until all sides of the frame fit tightly against the device.
Secure the Frame with Screws (optional)
If you do not expect to remove and reattach the frame to the device frequently, you may want to insert the original screws in the top and side holes of the frame. If you expect to remove and reattach the frame to the device frequently, you may not want to use the screws.
Place the device face-down on a flat surface.
Using the frame screws you removed earlier, insert two screws through the holes in the top of the frame and into corresponding holes in the top of the device.
Insert two screws through the holes in the sides of the frame and into the corresponding holes in the sides of the device.
Insert two screws through the holes in the bottom of the frame and into the corresponding holes in the bottom of the device.
Tighten all six screws with a Phillips screwdriver.
Note: After you attach the frame securely to the device, you can attach a keyguard or TouchGuide.