Using a Keyguard

Prev Next

Keyguards can be attached to a Genesis device to add a grid with deep rectangular openings aligned with the user’s vocabulary screen. This provides clear physical boundaries between touch selections to increase accuracy during communication. Keyguards open upward on a hinge and can be easily raised to access the device programming menus.

Attach a Keyguard

To attach a keyguard, make sure that a frame is attached to the Genesis device first. For instructions, see Attach a Frame.

  1. Hold the keyguard over the screen with the pins toward the top and the tabs toward the bottom.

    Important: Position the keyguard so that the tabs are on the bottom. The tabs must be able to lie flat against the screen, allowing the keyguard to snap into place.

  2. Insert one of the keyguard pins into the opening near the top of the device frame.

  3. While holding the pin in place, lift upward with your fingers to bend the middle of the keyguard upward slightly. Then insert the other pin into the opening on the other side of the device frame.

  4. Press down on the bottom portion of the keyguard to snap the tabs into place.

    Note: If the keyguard tabs at the bottom do not snap into place, make sure that the keyguard is not upside down. (refer to step 1)


Raise the Keyguard

If you need temporary access to the screen—for example, programming, changing device settings, cleaning the screen, etc.—you can raise the keyguard without removing it completely.

  1. While holding the bottom edge of the device with one hand, use the thumb of your other hand to grasp the bottom edge of the keyguard in the middle.

  2. Pull upward to release the bottom tabs.

  3. Leaving the pins inserted in the top of the device frame, lift the bottom of the keyguard to uncover the screen. The keyguard remains in the upright position, giving you easy access to the screen.


Remove the Keyguard

  1. While holding the bottom edge of the device with one hand, use the thumb of your other hand to grasp the bottom edge of the keyguard in the middle.

  2. Pull upward to release the bottom tabs.

  3. Lift upward with your fingers to bend the middle of the keyguard upward slightly.

  4. Pull the pins out of the openings at the top of the device frame.