Using a TouchGuide

Prev Next

TouchGuides can be attached to a Genesis device to add a grid with shallow oval openings aligned with the user’s vocabulary screen. This provides subtle boundaries between touch selections to increase accuracy during communication. TouchGuides do not open on a hinge and must be removed to access the device programming menus.

Attach a TouchGuide

To attach a TouchGuide, make sure that a frame is attached to the Genesis device first. For instructions, see Attach a Frame.

  1. Align the TouchGuide so that the two squares at the top are positioned at the upper right corner of the display.

  2. Insert the bottom tabs of the TouchGuide into the slots at the bottom edge of the frame.

  3. With the bottom tabs in place, lift upward with your fingers to bend the top right corner of the TouchGuide slightly and insert the tab into the top right slot of the frame.

    Note: The TouchGuide plastic is stiff and may require some effort to bend.

  4. Insert the left tab into the top left slot of the frame using the same method as in step 3.

  5. To make sure the TouchGuide fits flat against the screen, push down on the TouchGuide in each of the four corners to seat it into the rubber completely.

    Hint: Pulling up on the corners of the frame slightly while pushing down on the TouchGuide corners also helps to nestle the TouchGuide into the rubber.


Remove a TouchGuide

  1. Grasp the thicker plastic above the first row of openings.

    Note: Avoid pulling on the thin pieces of plastic.

  2. Pull out and down on the TouchGuide until the upper tabs pop out.