Important: The NuPoint® module must be securely attached to the device with all screws to operate properly.
If you purchased NuPoint with your Accent® device, the NuPoint module is already mounted on the device. If you purchased NuPoint later, follow these instructions to attach the module to the device. You can attach the module to a device with or without a frame.
Note: Your device may look slightly different from the device shown in these photos.
Remove the device handle or port cover by removing the two screws with a Phillips head screwdriver. You will use the screws you remove from the handle or port cover to fasten the NuPoint module to the device.
To remove the handle:
To remove the port cover:
Important: If the device has a frame attached, remove the two top screws that hold the frame in place. Otherwise, the NuPoint module will not attach properly. Store these screws in a safe location or discard them.
⚠️ Loose screws can be a choking hazard.Align the connector and screw holes on the NuPoint module with the NuPoint USB connector and screw holes on the top edge of the back of the device.
Slide the module into place, making sure the connectors are engaged completely.
Tighten the two screws you removed in step 1 to secure the module to the device.
The NuPoint module is ready to set up for use.
Head Tracking Status LED
The LED on the front of the NuPoint unit indicates the current tracking status. Red indicates that the NuPoint unit is on but is not tracking. Green indicates the unit is tracking.
